Last Modified: 08-21-2023 6.11:8.1.0 Doc ID: RM100000001B20F
Model Year Start: 2019 Model: Avalon HV Prod Date Range: [04/2018 -           ]
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: REMOVAL; 2019 - 2022 MY Avalon Avalon HV [04/2018 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

Blind spot monitor sensor

Blind spot monitor beam axis adjustment
  • Intelligent Clearance Sonar System
  • Blind Spot Monitor System

2019 - 2022 MY Avalon Avalon HV [04/2018 -        ]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: ADJUSTMENT

Rear bumper assembly
  • Measure ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Intelligent Clearance Sonar System
  • Intuitive Parking Assist System

2019 - 2022 MY Avalon [04/2018 -        ]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM (for Gasoline Model): CALIBRATION

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

Blind spot monitor sensor

Blind spot monitor beam axis adjustment
  • Intelligent Clearance Sonar System
  • Blind Spot Monitor System

2019 - 2022 MY Avalon Avalon HV [04/2018 -        ]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: ADJUSTMENT

Rear bumper assembly
  • Measure ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Intelligent Clearance Sonar System
  • Intuitive Parking Assist System

2019 - 2022 MY Avalon HV [04/2018 -        ]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM (for HV Model): CALIBRATION

PROCEDURE

1. REMOVE REAR BUMPER ASSEMBLY

Click here 2019 - 2022 MY Avalon Avalon HV [04/2018 -        ]; EXTERIOR PANELS / TRIM: REAR BUMPER: REMOVAL

2. REMOVE BLIND SPOT MONITOR SENSOR LH

(a) Disconnect the connector.

(b) Remove the 3 nuts and blind spot monitor sensor LH.

NOTICE:

Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.

3. REMOVE BLIND SPOT MONITOR SENSOR RH

(a) Disconnect the connector.

(b) Remove the 3 nuts and blind spot monitor sensor RH.

NOTICE:

Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.