Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001B1NO |
Model Year Start: 2019 |
Model: Avalon HV |
Prod Date Range: [04/2018 -
] |
Title: LIGHTING (EXT): HEADLIGHT ECU: REMOVAL; 2019 - 2022 MY Avalon Avalon HV [04/2018 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Front bumper assembly
|
-
Measurement of ultrasonic sensor detection angle
-
Ultrasonic sensor detection angle registration
|
-
Intelligent Clearance Sonar System
-
Intuitive Parking Assist System
|
|
Front television camera view adjustment
|
Panoramic View Monitor System
|
|
-
Headlight assembly LH
-
Headlight ECU sub-assembly LH
|
Synchronize the vehicle information
|
Lighting system (for Gasoline Model with Cornering Light)
|
|
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Front bumper assembly
|
-
Measurement of ultrasonic sensor detection angle
-
Ultrasonic sensor detection angle registration
|
-
Intelligent Clearance Sonar System
-
Intuitive Parking Assist System
|
|
Front television camera view adjustment
|
Panoramic View Monitor System
|
|
-
Headlight assembly LH
-
Headlight ECU sub-assembly LH
|
Synchronize the vehicle information
|
Lighting system (for HV Model with Cornering Light)
|
|
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE HEADLIGHT ASSEMBLY
Click here
2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY
NOTICE:
-
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
-
If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
(a) Using a T25 "TORX" socket wrench, remove the 3 screws.
|
|
(b) Separate the connector cover from the headlight ECU sub-assembly.
|
|
(c) Disconnect the 2 connectors to remove the headlight ECU sub-assembly.
|
|
3. REMOVE HEADLIGHT GASKET
NOTICE:
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
(a) Remove the headlight gasket.
|
|
|