| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001B1NK |
| Model Year Start: 2019 | Model: Avalon HV | Prod Date Range: [04/2018 - ] |
| Title: LIGHTING (EXT): AUTOMATIC LIGHT CONTROL SENSOR: ON-VEHICLE INSPECTION; 2019 - 2022 MY Avalon Avalon HV [04/2018 - ] | ||
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR
|
(a) Disconnect the G23 automatic light control sensor connector. |
|
(b) Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
*1: for HV Model
*2: for Gasoline Model |
||
|
G23-1 (CLTB) - G23-2 (CLTE) |
Power switch off*1 |
Below 1 V |
|
Engine switch off*2 |
||
|
Power switch on (IG)*1 |
11 to 14 V |
|
|
Engine switch on (IG)*2 |
||
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
G23-2 (CLTE) - Body ground |
Always |
Below 1 Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Connect the G23 automatic light control sensor connector.
(d) Connect an oscilloscope to terminals G23-2 (CLTE) and G23-4 (CLTS) of the automatic light control sensor connector and check the waveform.
|
*a |
Component with harness connected (Automatic Light Control Sensor) |
*b |
Waveform |
OK:
|
Tester Connection |
Condition |
Tool Setting |
Specified Condition |
|---|---|---|---|
|
*1: for HV Model
*2: for Gasoline Model |
|||
|
G23-2 (CLTE) - G23-4 (CLTS) |
Power switch on (IG)*1 |
2 V/DIV., 10 ms./DIV. |
Pulse generation (See waveform) |
|
Engine switch on (IG)*2 |
|||
HINT:
The communication waveform changes according to the surrounding brightness.
If the result is not as specified, the automatic light control sensor may be malfunctioning.
|
|