| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001B1ND |
| Model Year Start: 2019 | Model: Avalon HV | Prod Date Range: [04/2018 - ] |
| Title: LIGHTING (EXT): AUTOMATIC HIGH BEAM MAIN SWITCH: INSPECTION; 2019 - 2022 MY Avalon Avalon HV [04/2018 - ] | ||
INSPECTION
PROCEDURE
1. INSPECT AUTO HIGH BEAM SWITCH
|
*a |
Component without harness connected (Auto High Beam Switch) |
(a) Check the switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
5 (+B) - 2 (E) |
Auto high beam switch not pressed |
10 kΩ or higher |
|
Auto high beam switch pressed |
Below 1 Ω |
If the result is not as specified, replace the auto high beam switch.
(b) Inspect the switch illumination.
(1) Apply auxiliary battery voltage to the auto high beam switch and check that the switch illuminates.
OK:
|
Measurement Condition |
Specified Condition |
|---|---|
|
Auxiliary battery positive (+) → Terminal 6 (ILL+) Auxiliary battery negative (-) → Terminal 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the auto high beam switch.
(c) Inspect the indicator illumination.
(1) Apply auxiliary battery voltage to the auto high beam switch and check that the indicator illuminates.
OK:
|
Measurement Condition |
Specified Condition |
|---|---|
|
Auxiliary battery positive (+) → Terminal 3 (IND+) Auxiliary battery negative (-) → Terminal 4 (AZBI) |
Illuminates |
If the result is not as specified, replace the auto high beam switch.
|
|