Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001B1M6 |
Model Year Start: 2019 |
Model: Avalon HV |
Prod Date Range: [04/2018 -
] |
Title: LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL; 2019 - 2022 MY Avalon Avalon HV [04/2018 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Front bumper assembly
|
-
Measurement of ultrasonic sensor detection angle
-
Ultrasonic sensor detection angle registration
|
-
Intelligent Clearance Sonar System
-
Intuitive Parking Assist System
|
|
Front television camera view adjustment
|
Panoramic View Monitor System
|
|
-
Headlight assembly LH
-
Headlight ECU sub-assembly LH
|
Synchronize the vehicle information
|
Lighting system (for Gasoline Model with Cornering Light)
|
|
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
Front bumper assembly
|
-
Measurement of ultrasonic sensor detection angle
-
Ultrasonic sensor detection angle registration
|
-
Intelligent Clearance Sonar System
-
Intuitive Parking Assist System
|
|
Front television camera view adjustment
|
Panoramic View Monitor System
|
|
-
Headlight assembly LH
-
Headlight ECU sub-assembly LH
|
Synchronize the vehicle information
|
Lighting system (for HV Model with Cornering Light)
|
|
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here
2. REMOVE HEADLIGHT ASSEMBLY
(a) Apply protective tape around the headlight assembly as shown in the illustration.
|
Protective Tape
|
(b) w/o Cornering Light:
(1) Remove the bolt (A) , bolt (B) and 3 screws.
|
|
*a
|
Bolt (A)
|
*b
|
Bolt (B)
|
*c
|
Screw
|
|
|
(2) Disengage the guide to separate the headlight assembly as shown in the illustration.
|
Remove in this Direction
|
(3) Disconnect the connector to remove the headlight assembly.
(c) w/ Cornering Light:
(1) Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector.
*a
|
Connector Lock Lever
|
|
Disconnect in this Direction
|
(2) Remove the bolt (A) , bolt (B) and 3 screws.
|
|
*a
|
Bolt (A)
|
*b
|
Bolt (B)
|
*c
|
Screw
|
|
|
(3) Disengage the guide to remove the headlight assembly as shown in the illustration.
|
Remove in this Direction
|
|