2GR-FKS (ENGINE CONTROL): RELAY: ON-VEHICLE INSPECTION; 2019 - 2022 MY Avalon [04/2018 - ]

Last Modified: 08-21-2023	6.11:8.1.0	Doc ID: RM100000001AYTD
Model Year Start: 2019	Model: Avalon	Prod Date Range: [04/2018 - ]
Title: 2GR-FKS (ENGINE CONTROL): RELAY: ON-VEHICLE INSPECTION; 2019 - 2022 MY Avalon [04/2018 - ]

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT NO. 1 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI-MAIN NO. 1)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Battery voltage not applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Battery voltage applied between terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the No. 1 electronic fuel injection main relay (EFI-MAIN NO. 1).

2. INSPECT NO. 2 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI-MAIN NO. 2)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Battery voltage not applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Battery voltage applied between terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the No. 2 electronic fuel injection main relay (EFI-MAIN NO. 2).

3. INSPECT NO. 3 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI-MAIN NO. 3)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Battery voltage not applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Battery voltage applied between terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the No. 3 electronic fuel injection main relay (EFI-MAIN NO. 3).

4. INSPECT INJECTOR RELAY (D INJ)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Battery voltage not applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Battery voltage applied between terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the injector relay (D INJ).

5. INSPECT NO. 2 IGNITION RELAY (IG2 NO. 1)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Battery voltage not applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Battery voltage applied between terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the No. 2 ignition relay (IG2 NO. 1).