- Side television camera assembly LH
- Outer rear view mirror assembly LH
- Side television camera assembly RH
- Outer rear view mirror assembly RH
| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001AYQF |
| Model Year Start: 2019 | Model: Avalon HV | Prod Date Range: [04/2018 - ] |
| Title: MIRROR (EXT): OUTER REAR VIEW MIRROR: REMOVAL; 2019 - 2022 MY Avalon Avalon HV [04/2018 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during outer rear view mirror assembly with cover removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
|
Side television camera view adjustment |
Panoramic view monitor system |
|
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
Side television camera view adjustment |
Panoramic view monitor system |
|
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY
Click here
![2019 - 2020 MY Avalon Avalon HV [04/2018 - 08/2020]; DOOR / HATCH: FRONT DOOR: DISASSEMBLY+](/t3Portal/stylegraphics/info.gif)
2. REMOVE FRONT DOOR TRIM POCKET COVER
Click here
3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
5. REMOVE COURTESY LIGHT ASSEMBLY
Click here
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
7. REMOVE HOLE PLUG
|
(a) Remove the hole plug. |
|
8. REMOVE OUTER MIRROR INSTALL HOLE COVER
|
(a) Disconnect the connector. |
|
(b) Disengage the clamp.
|
(c) Remove the screw. |
|
(d) Disengage the clip and 2 claws to remove the outer mirror install hole cover.
9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
|
(a) Disengage the clamp. |
|
(b) Remove the 3 nuts.
(c) Disengage the claw and 2 guides, and remove the outer rear view mirror assembly with cover.
|
|