Last Modified: 08-21-2023 6.11:8.1.0 Doc ID: RM100000001AY8X
Model Year Start: 2019 Model: Avalon Prod Date Range: [04/2018 -           ]
Title: HEATING / AIR CONDITIONING: AMBIENT TEMPERATURE SENSOR (for Gasoline Model): REMOVAL; 2019 - 2022 MY Avalon [04/2018 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermistor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link
*: Applies only for when removing and installing or replacing the television camera assembly.

Front television camera assembly, front bumper assembly or radiator grille
  • Television camera view adjustment
  • Television camera assembly optical axis adjustment (Back camera position setting)*

Panoramic View Monitor System

2019 - 2022 MY Avalon [04/2018 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for Gasoline Model): INITIALIZATION for Initialization

2019 - 2022 MY Avalon [04/2018 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for Gasoline Model): CALIBRATION Calibration

Front bumper assembly
  • Measurement of ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Intelligent Clearance Sonar System
  • Intuitive Parking Assist System

2019 - 2022 MY Avalon [04/2018 -        ]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM (for Gasoline Model): CALIBRATION

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

Click here 2019 - 2021 MY Avalon Avalon HV [04/2018 - 08/2021]; EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL 2022 MY Avalon Avalon HV [08/2021 -        ]; EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL

2. REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH

(a) Disengage the 2 claws to remove the front radiator side air guide plate RH.

3. REMOVE THERMISTOR ASSEMBLY

(a) Disengage the clamp.

(b) Disconnect the connector to remove the thermistor assembly.