Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM100000001AWII |
Model Year Start: 2019 |
Model: Avalon HV |
Prod Date Range: [04/2018 - 08/2021] |
Title: PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM (for HV Model): C1245; Deceleration Sensor; 2019 - 2021 MY Avalon HV [04/2018 - 08/2021] |
DTC
|
C1245
|
Deceleration Sensor
|
DESCRIPTION
The parking brake ECU (brake actuator assembly) receives vehicle tilt angle information from the deceleration sensor (airbag ECU assembly) via CAN communication.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
Memory
|
Note
|
C1245
|
Deceleration Sensor
|
One of following conditions is met:
-
An error signal is sent from deceleration sensor (airbag ECU assembly) for approximately 0.3 seconds.
-
While the deceleration sensor (airbag ECU assembly) signal is judged to be stuck, starting off and stopping of vehicle occurs 16 times.
-
Comparison error between deceleration sensor (airbag ECU assembly) 1 and deceleration sensor (airbag ECU assembly) 2 output values occurs for 60 seconds or more.
|
Deceleration sensor (Airbag ECU assembly)
|
DTC stored
|
An electric parking brake system malfunction is displayed on the multi-information display.
|
DTC Detection Conditions
|
Vehicle Condition
|
Pattern 1
|
Pattern 2
|
Pattern 3
|
Diagnosis Condition
|
Power switch on (IG)
|
○
|
○
|
○
|
Malfunction Status
|
An error signal is sent from the deceleration sensor (airbag ECU assembly)
|
○
|
-
|
-
|
While the deceleration sensor (airbag ECU assembly) signal is judged to be stuck, starting off and stopping the vehicle occurs 16 times
|
-
|
○
|
-
|
Comparison error between deceleration sensor (airbag ECU assembly) 1 and deceleration sensor (airbag ECU assembly) 2 output values occurs
|
-
|
-
|
○
|
Detection Time
|
Approximately 0.3 seconds
|
-
|
60 seconds or more
|
Number of Trips
|
1 trip
|
1 trip
|
1 trip
|
HINT:
DTC will be output when conditions for either of the patterns in the table above are met.
CAUTION / NOTICE / HINT
NOTICE:
When replacing the deceleration sensor (airbag ECU assembly), perform initialization and calibration of the linear solenoid valve.
Click here
PROCEDURE
1.
|
CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
|
(a) Check for DTCs.
Chassis > ABS/VSC/TRAC > Trouble Codes
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
A
|
|
|
2.
|
CHECK DTC (ELECTRIC PARKING BRAKE SYSTEM)
|
(a) Clear the DTCs.
Chassis > Electric Parking Brake > Clear DTCs
(b) Turn the power switch off.
(c) Check for DTCs.
Chassis > Electric Parking Brake > Trouble Codes
Result
|
Proceed to
|
DTCs are output
|
A
|
DTCs are not output
|
B
|
|