| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001ATWQ |
| Model Year Start: 2019 | Model: Avalon HV | Prod Date Range: [04/2018 - 08/2020] |
| Title: STEERING COLUMN: STEERING WHEEL: INSTALLATION; 2019 - 2020 MY Avalon Avalon HV [04/2018 - 08/2020] | ||
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
- Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the engine switch (for Gasoline Model) or power switch (for HV Model) on (IG).
- Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the engine switch (for Gasoline Model) or power switch (for HV Model) on (IG).
- Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
PROCEDURE
1. INSTALL NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)
for Gasoline Model: Click here
![2019 - 2022 MY Avalon [04/2018 - ]; UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE): SHIFT PADDLE SWITCH: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
for HV Model: Click here
2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)
for Gasoline Model: Click here
for HV Model: Click here
3. INSTALL STEERING PAD SWITCH ASSEMBLY
Click here
4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
5. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here
6. INSTALL STEERING WHEEL ASSEMBLY
|
(a) Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly. |
|
(b) Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt.
Torque:
62 N·m {632 kgf·cm, 46 ft·lbf}
(c) Connect each connector to the spiral cable with sensor sub-assembly and steering wheel assembly.
7. CHECK STEERING WHEEL CENTER POINT
8. INSTALL HORN BUTTON ASSEMBLY
Click here
|
|