| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001ARA7 |
| Model Year Start: 2019 | Model: Avalon HV | Prod Date Range: [04/2018 - 08/2020] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Front Passenger Side): INSTALLATION; 2019 - 2020 MY Avalon Avalon HV [04/2018 - 08/2020] | ||
INSTALLATION
PROCEDURE
1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off.
(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
(c) Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.
|
*a |
Airbag Connector |
|
*b |
Airbag Connector Locking Button |
|
Push in this Direction |
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(d) Push in the airbag connector locking button to install the airbag connector.
(e) Engage the 3 claws to temporarily install the lower No. 2 instrument panel airbag assembly.
(f) Install the lower No. 2 instrument panel airbag assembly with the 3 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Click here
![2019 - 2020 MY Avalon Avalon HV [04/2018 - 08/2020]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL INSTRUMENT SIDE PANEL RH
Click here
5. INSTALL GLOVE COMPARTMENT PLATE
Click here
6. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
Click here
8. INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for Gasoline Model: Click here
for HV Model: Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
10. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HV Model)
Click here
11. PERFORM DIAGNOSTIC SYSTEM CHECK
for Gasoline Model: Click here
for HV Model: Click here
12. INSPECT SRS WARNING LIGHT
for Gasoline Model: Click here
for HV Model: Click here
|
|