| Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001AQWP |
| Model Year Start: 2019 | Model: Avalon HV | Prod Date Range: [04/2018 - ] |
| Title: DOOR / HATCH: FUEL LID OPENER MOTOR ASSEMBLY: INSPECTION; 2019 - 2022 MY Avalon Avalon HV [04/2018 - ] | ||
INSPECTION
PROCEDURE
1. INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY
(a) Check the operation of the fuel lid lock with motor assembly (motor operation).
(1) Apply auxiliary battery voltage to the fuel lid lock with motor assembly connector, and check the operation of the fuel lid lock with motor assembly.
|
*a |
Component without harness connected (Fuel Lid Lock with Motor Assembly) |
*b |
Shaft Stroke |
|
*c |
Lever |
*d |
Shaft |
OK:
|
Auxiliary Battery Connection |
Specified Condition |
|---|---|
|
Auxiliary battery positive (+) → Terminal 1 Auxiliary battery negative (-) → Terminal 2 |
Shaft retracts |
If the result is not as specified, replace the fuel lid lock with motor assembly.
(b) Check the operation of the fuel lid lock with motor assembly (fuel lid courtesy switch).
(1) Measure the resistance according the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
2 - 3 |
Shaft not pushed (On) |
Below 1 Ω |
|
2 - 3 |
Shaft pushed (Off) |
10 kΩ or higher |
If the result is not as specified, replace the fuel lid lock with motor assembly.
(c) Measure the shaft stroke.
Standard:
|
Area |
Condition |
Specified Condition |
|---|---|---|
|
Shaft stroke |
Lever pulled |
16.05 mm (0.632 in.) |
If the result is not as specified, replace the fuel lid lock with motor assembly.
|
|