| 
                     
                        | Last Modified: 08-21-2023 | 6.11:8.1.0 | Doc ID: RM100000001ANBE |  
                        | Model Year Start: 2019 | Model: Avalon | Prod Date Range: [04/2018 -                    
                                       ] |  
                        | Title: NETWORKING: CAN COMMUNICATION SYSTEM (for Gasoline Model): Parking Assist ECU Communication Stop Mode; 2019 - 2022 MY Avalon [04/2018 -        ] |  
                     
                        
                           | Parking Assist ECU Communication Stop Mode |  DESCRIPTION
                     
                        
                        
                        
                     
                     
                        
                           | Detection Item | Symptom | Trouble Area |  
                           | Parking Assist ECU Communication Stop Mode | Any of the following conditions are met: | 
                                 
                                    
Parking assist ECU branch line or connector
Power source circuit of parking assist ECU
Parking assist ECU ground circuit
Parking assist ECU
 |  WIRING DIAGRAM  CAUTION / NOTICE / HINTCAUTION: When performing the confirmation driving pattern, obey all speed limits and traffic laws. 
                     HINT: 
                        
Before disconnecting related connectors for inspection, push in on each connector body to check that the connector is not loose or disconnected.
When a connector is disconnected, check that the terminals and connector body are not cracked, deformed or corroded.
 PROCEDURE
                     
                        
                           | 1.  | CHECK FOR OPEN IN CAN BUS LINES (PARKING ASSIST ECU BRANCH LINE) |  (a) Disconnect the cable from the negative (-) battery terminal. (b) Disconnect the K35 parking assist ECU connector. 
                     
                        
                           | (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:  
                                 
                                 
                                 
                                 
                                    
                                       | Tester Connection | Condition | Specified Condition |  
                                       | K35-12 (CANH) - K35-13 (CANL) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |  | 
                                 
                                    |   |  
                                    | 
                                          
                                             
                                             
                                          
                                          
                                             
                                                | *a | Front view of wire harness connector (to Parking Assist ECU) |  |  |  
                     
                        
                           | NG |   | REPAIR OR REPLACE CAN BRANCH LINES OR CONNECTOR (PARKING ASSIST ECU) |  
                     
                        | 
                              
                                 | OK |  
                                 |   |  |  
                     
                        
                           | 2.  | CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |  
                     
                        
                           | (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:  
                                 
                                 
                                 
                                 
                                    
                                       | Tester Connection | Condition | Specified Condition |  
                                       | K35-3 (GND1) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |  | 
                                 
                                    |   |  
                                    | 
                                          
                                             
                                             
                                          
                                          
                                             
                                                | *a | Front view of wire harness connector (to Parking Assist ECU) |  |  |  (b) Reconnect the cable to the negative (-) battery terminal. (c) Measure the voltage according to the value(s) in the table below. Standard Voltage:  
                     
                        
                        
                        
                     
                     
                        
                           | Tester Connection | Condition | Specified Condition |  
                           | K35-2 (+B) - Body ground | Always | 11 to 14 V |  
                           | K35-1 (ACC) - Body ground | Engine switch on (ACC) | 11 to 14 V |  
                           | K35-6 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |  
                     
                        
                           | NG |   | REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |  |