Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM1000000019XOA |
Model Year Start: 2019 |
Model: Avalon |
Prod Date Range: [04/2018 -
] |
Title: HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM (for Gasoline Model): ECO Switch Circuit; 2019 - 2022 MY Avalon [04/2018 - ] |
DESCRIPTION
When the ECO switch assembly (electric parking brake switch assembly) is operated, the air conditioning amplifier assembly receives a signal and enables or disables ECO mode control of the air conditioning system.
Symptom
|
Factor
|
When ECO switch assembly (electric parking brake switch assembly) is operated, blower speed does not change
|
-
Air conditioning amplifier assembly malfunction
-
ECO switch assembly (electric parking brake switch assembly) malfunction
-
Harness or connector
|
WIRING DIAGRAM
PROCEDURE
1.
|
READ VALUE USING TECHSTREAM
|
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Air Conditioner > Data List
Tester Display
|
Measurement Item
|
Range
|
Normal Condition
|
Diagnostic Note
|
ECO Switch
|
ECO switch assembly (electric parking brake switch assembly)
|
OFF or ON
|
OFF: ECO switch assembly (electric parking brake switch assembly) not pushed
ON: ECO switch assembly (electric parking brake switch assembly) pushed and held
|
ECO switch assembly (electric parking brake switch assembly) circuit malfunction
|
Body Electrical > Air Conditioner > Data List
Tester Display
|
ECO Switch
|
OK:
ECO switch assembly (electric parking brake switch assembly) condition displayed on the Techstream changes with the actual switch operation.
NG
|
|
|
2.
|
INSPECT ECO SWITCH ASSEMBLY (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
|
(a) Remove the ECO switch assembly (electric parking brake switch assembly).
Click here
(b) Inspect the ECO switch assembly (electric parking brake switch assembly).
Click here
OK
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (ECO SWITCH ASSEMBLY (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
|
(a) Disconnect the G36 air conditioning amplifier assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G24-11 (ECU) - G36-20 (ECOS)
|
Always
|
Below 1 Ω
|
G24-16 (GND1) - Body ground
|
Always
|
Below 1 Ω
|
G24-11 (ECU) or G36-20 (ECOS) - Other terminals and body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|