|
Last Modified: 08-21-2023 |
6.11:8.1.0 |
Doc ID: RM1000000019H79 |
|
Model Year Start: 2019 |
Model: Avalon |
Prod Date Range: [04/2018 -
] |
|
Title: BRAKE SYSTEM (OTHER): VACUUM PUMP (for 2GR-FKS): INSTALLATION; 2019 - 2022 MY Avalon [04/2018 - ] |
INSTALLATION
PROCEDURE
1. INSTALL VACUUM PUMP ASSEMBLY
(a) Clean the vacuum pump assembly installation bolt holes in the camshaft housing sub-assembly and cylinder head sub-assembly.
(b) When using a new vacuum pump assembly:
(1) Apply engine oil to the 2 O-rings which are installed to a new vacuum pump assembly.
|
Engine oil
|
(c) When reusing the vacuum pump assembly:
(1) Apply engine oil to 2 new O-rings and install them to the vacuum pump assembly.
|
Engine oil
|
(d) Apply engine oil to the inner surface of the installation hole.
|
(e) Temporarily install the vacuum pump assembly so that the oil pipe engages with the hole of the camshaft and the coupling teeth engages with the groove of the camshaft.
NOTICE:
-
Ensure that the vacuum pump assembly is installed securely.
-
Be careful not to pinch the O-ring.
|
|
|
*a
|
Coupling Teeth
|
|
*b
|
Groove
|
|
*c
|
Oil Pipe
|
|
|
|
(f) Install the vacuum pump assembly with 3 new bolts.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
NOTICE:
-
After installation, check that there are no gaps between the matching surfaces and that the vacuum pump assembly is not installed at an angle.
-
Tighten the 3 bolts in the order shown in the illustration.
|
|
2. CONNECT AIR TUBE
|
(a) Connect the air tube to the vacuum pump assembly, and slide the clip to secure it.
|
|
3. INSTALL ENGINE WIRE
|
(a) Install the earth wire with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
|
|
|
(b) Install the engine wire with the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
|
|
4. INSTALL NO. 2 SURGE TANK STAY
|
(a) Install the No. 2 surge tank stay with the 2 bolts in the order shown in the illustration.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
|
|
5. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Click here
6. INSPECT VACUUM PUMP OPERATION
Click here
|