Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000026AH6 |
Model Year Start: 2023 |
Model: Camry HV |
Prod Date Range: [08/2022 -
] |
Title: NETWORKING: NETWORK GATEWAY ECU: REMOVAL; 2023 - 2024 MY Camry HV [08/2022 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during central gateway ECU (network gateway ECU) removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision System
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking Assist Monitor System
|
|
Panoramic View Monitor System
|
|
Replacement of certification ECU (smart key ECU assembly)
|
Code registration (Smart key System (for Start Function))
|
-
Wireless door lock control system
-
Smart key system (for Entry Function)
-
Smart key system (for Start Function)
|
|
Replacement of clearance warning ECU assembly
|
-
Measurement of ultrasonic sensor detection angle
-
Bumper type registration
-
Ultrasonic sensor detection angle registration
|
-
Parking Support Brake System
-
Intuitive Parking Assist System
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
2. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Click here
3. REMOVE ECU INTEGRATION BOX RH
(a) Disconnect each connector.
(b) Disengage the 2 clamps.
|
|
(c) Remove the bolt, nut and ECU integration box RH.
4. REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)
(a) Disengage the 2 claws and remove the central gateway ECU (network gateway ECU).
NOTICE:
-
If the ECU integration box is deformed or damaged, replace it.
-
Do not bend the 2 claws more than necessary.
|
|
|