Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000024AWZ |
Model Year Start: 2023 |
Model: Camry HV |
Prod Date Range: [08/2022 -
] |
Title: THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function): B2781; Open / Short in Steering Lock ECU; 2023 - 2024 MY Camry HV [08/2022 - ] |
DTC
|
B2781
|
Open / Short in Steering Lock ECU
|
DESCRIPTION
As this DTC is not normally output, it may be due to noise in the LIN communication system, etc.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
Note
|
B2781
|
Open / Short in Steering Lock ECU
|
Noise in the LIN communication system, etc.
|
ID code box (immobiliser code ECU)
|
DTC Output Confirmation Operation:
-
No confirmation operation is necessary (monitoring is continuous).
|
Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected
|
Fail-safe Function when Malfunction Detected
|
The hybrid control system cannot be started.
|
Prohibits the hybrid control system from being started (the hybrid control system does not start).
|
Related Data List and Active Test Items
DTC No.
|
Data List and Active Test
|
B2781
|
-
|
CAUTION / NOTICE / HINT
NOTICE:
-
When using the Techstream with the power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
-
The smart key system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
Click here
-
Before replacing the ID code box (immobiliser code ECU), refer to Registration.
Click here
-
After performing repairs, confirm that no DTCs are output again.
Click here
HINT:
When all the ECUs that are connected via LIN communication cannot communicate with the certification ECU (smart key ECU assembly), DTC B2785 is stored.
PROCEDURE
(a) Clear the DTCs.
Body Electrical > Smart Key > Clear DTCs
NEXT
|
|
|
(a) Check for DTCs.
Body Electrical > Smart Key > Trouble Codes
OK:
DTC B2781 is not output.
OK |
|
END
|
|