Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001T9BP |
Model Year Start: 2021 |
Model: Camry HV |
Prod Date Range: [10/2020 -
] |
Title: LIGHTING (EXT): HEADLIGHT ECU: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Front bumper assembly (w/ Panoramic view monitor system)
|
Front television camera view adjustment
|
Panoramic view monitor system
|
|
Replacement or removal and installation of 2 or more parts:
-
Front television camera assembly, front bumper assembly or radiator grille
-
Rear television camera assembly
-
Side television camera assembly LH or outer rear view mirror assembly LH
-
Side television camera assembly RH or outer rear view mirror assembly RH
|
Television camera view adjustment
|
-
Headlight ECU sub-assembly LH
-
Headlight assembly LH
|
-
Synchronize the vehicle information
-
Perform headlight ECU sub-assembly LH initialization
|
Lighting system (w/ AFS)(EXT)
|
|
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE HEADLIGHT ASSEMBLY
Click here
2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY
NOTICE:
-
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
-
If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
(b) Separate the connector cover from the headlight ECU sub-assembly.
|
|
(c) Disconnect the 2 connectors to remove the headlight ECU sub-assembly.
|
|
3. REMOVE HEADLIGHT GASKET
NOTICE:
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
(a) Remove the headlight gasket.
|
|
|