LIGHTING (EXT): HEADLIGHT ECU: REMOVAL; 2021 - 2024 MY Camry HV [10/2020

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM100000001T9BP
Model Year Start: 2021	Model: Camry HV	Prod Date Range: [10/2020 - ]
Title: LIGHTING (EXT): HEADLIGHT ECU: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed
Front bumper assembly (w/ Panoramic view monitor system)	Front television camera view adjustment	Panoramic view monitor system
Replacement or removal and installation of 2 or more parts: Front television camera assembly, front bumper assembly or radiator grille Rear television camera assembly Side television camera assembly LH or outer rear view mirror assembly LH Side television camera assembly RH or outer rear view mirror assembly RH	Television camera view adjustment	Panoramic view monitor system
Headlight ECU sub-assembly LH Headlight assembly LH	Synchronize the vehicle information Perform headlight ECU sub-assembly LH initialization	Lighting system (w/ AFS)(EXT)

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. REMOVE HEADLIGHT ASSEMBLY

Click here

2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.

(a) Remove the 3 screws.

(b) Separate the connector cover from the headlight ECU sub-assembly.

3. REMOVE HEADLIGHT GASKET