Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001T9BM
Model Year Start: 2021 Model: Camry HV Prod Date Range: [10/2020 -           ]
Title: LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Front bumper assembly (w/ Panoramic view monitor system)

Front television camera view adjustment

Panoramic view monitor system

2021 - 2024 MY Camry HV [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

Replacement or removal and installation of 2 or more parts:

  • Front television camera assembly, front bumper assembly or radiator grille
  • Rear television camera assembly
  • Side television camera assembly LH or outer rear view mirror assembly LH
  • Side television camera assembly RH or outer rear view mirror assembly RH

Television camera view adjustment
  • Headlight ECU sub-assembly LH
  • Headlight assembly LH
  • Synchronize the vehicle information
  • Perform headlight ECU sub-assembly LH initialization

Lighting system (w/ AFS)(EXT)

2021 - 2024 MY Camry HV [10/2020 -        ]; LIGHTING (EXT): LIGHTING SYSTEM (w/ AFS): INITIALIZATION

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT BUMPER ASSEMBLY

Click here 2021 - 2024 MY Camry HV [10/2020 -        ]; EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL

2. REMOVE HEADLIGHT ASSEMBLY

(a) Apply protective tape around the headlight assembly as shown in the illustration.

Protective Tape

(b) Remove the bolt and 3 screws.

*a

Bolt

*b

Screw

(c) Disengage the guide to separate the headlight assembly as shown in the illustration.

Remove in this Direction

(d) for Bulb Type Turn Signal Light:

(1) Disengage the clamp.

(e) w/o AFS:

(1) Disconnect each connector to remove the headlight assembly.

(f) w/ AFS:

(1) Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector to remove the headlight assembly.

*a

Connector Lock Lever

Disconnect in this Direction