Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001T8MA |
Model Year Start: 2021 |
Model: Camry HV |
Prod Date Range: [10/2020 -
] |
Title: SEAT: LUMBAR SUPPORT ADJUSTER ASSEMBLY: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane tracing assist system
|
|
Pre-collision system
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
CAUTION:
-
Be sure to read Precaution thoroughly before servicing.
Click here
-
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
Click here
2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Click here
3. REMOVE FRONT SEAT FRONT CUSHION SHIELD LH
Click here
4. REMOVE FRONT SEAT CUSHION SHIELD LH
Click here
5. REMOVE FRONT SEAT INNER CUSHION SHIELD LH
Click here
6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Click here
7. REMOVE FRONT SEAT HEADREST SUPPORT
Click here
8. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Click here
9. REMOVE SEATBACK CLIMATE CONTROL BLOWER (w/ Climate Control Seat System)
(a) Disengage the wire harness clamp and disconnect the connector.
HINT:
Disengage the wire harness clamp first.
|
|
(b) Disengage the 2 claws and 3 hooks to remove the seatback climate control blower.
HINT:
Disengage the 2 claws first.
|
|
10. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH
(a) w/o Climate Control Seat System:
(1) Disengage the clamp and disconnect the connector.
HINT:
Disengage the clamp first.
|
|
(2) Disengage the 8 hooks to remove the lumbar support adjuster assembly LH.
|
|
(b) w/ Climate Control Seat System:
(1) Disengage the clamp and disconnect the connector.
HINT:
Disengage the clamp first.
|
|
(2) Disengage the 2 claws.
|
|
(3) Disengage the 2 guides to remove the lumbar support adjuster assembly LH as shown in the illustration.
|
Remove in this Direction
|
|