Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001T66Y |
Model Year Start: 2021 |
Model: Camry HV |
Prod Date Range: [10/2020 -
] |
Title: LIGHTING (EXT): SWITCH HOUSING: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel switch housing removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Removal/installation of the spiral cable with sensor sub-assembly
|
-
Steering angle neutral point (Initialize parking assist monitor system)
-
Steering angle setting
|
Parking assist monitor system
|
for Initialization
for Calibration
|
Steering angle neutral point (Initialize panoramic view monitor system)
|
Panoramic view monitor system
|
Steering angle neutral point (Initialize intelligent clearance sonar system)
|
-
Intelligent clearance sonar system
-
Intuitive parking assist system
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision System
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here
2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Click here
3. REMOVE TURN SIGNAL SWITCH
Click here
4. REMOVE STEERING WHEEL SWITCH HOUSING
(a) Using pliers, expand the clamp as shown in the illustration.
|
|
(b) While holding the clamp expanded, using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the steering wheel switch housing as shown in the illustration.
*a
|
Protective Tape
|
|
Remove in this Direction
|
|