Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001T65Z |
Model Year Start: 2021 |
Model: Camry HV |
Prod Date Range: [10/2020 -
] |
Title: SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
-
Sliding roof ECU (sliding roof drive gear sub-assembly)
-
Sliding roof glass sub-assembly
-
Sliding roof drive cable sub-assembly
-
Sliding roof drive gear sub-assembly
|
Initialize Sliding Roof System
|
-
Auto operation function
-
Jam protection function
-
Key-off operation function
-
Key-linked function
-
Wireless transmitter-linked function
-
Sliding roof open warning function
|
|
Disconnect cable from negative (-) auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision System
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking Assist Monitor System
|
|
Panoramic view monitor system
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE SLIDING ROOF SIDE GARNISH LH
(a) Disengage the 4 claws to remove the sliding roof side garnish LH.
|
|
2. REMOVE SLIDING ROOF SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
3. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY
(a) Move the sliding roof glass sub-assembly to the fully closed position.
(b) Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.
NOTICE:
To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from becoming misaligned, move the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly) to the fully closed position before removing it.
4. REMOVE SLIDING ROOF WEATHERSTRIP
(a) Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.
|
|
5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
Click here
6. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
7. DISCONNECT SLIDING ROOF DRAIN HOSE
HINT:
Use the same procedure for all of the sliding roof drain hoses.
(a) for Clamp Type:
(1) Disengage the claw and disconnect the sliding roof drain hose.
|
|
(b) for Clip Type:
(1) Expand the clip and disconnect the sliding roof drain hose.
|
|
8. REMOVE SLIDING ROOF HOUSING ASSEMBLY
(a) Remove the 8 bolts, 6 nuts and sliding roof housing assembly.
|