| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001T5PO |
| Model Year Start: 2021 | Model: Camry HV | Prod Date Range: [10/2020 - ] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat position airbag sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane tracing assist system |
|
|
Pre-collision system |
|||
|
Lighting system (w/ AFS)(EXT) |
|||
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
|
Panoramic view monitor system |
|
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
for Manual Seat: Click here
![2021 - 2024 MY Camry HV [10/2020 - ]; SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): REMOVAL](/t3Portal/stylegraphics/info.gif)
for Power Seat: Click here
2. REMOVE SEAT POSITION AIRBAG SENSOR
|
(a) Disengage the clamp and disconnect the connector. |
|
|
(b) Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor with the seat slide position sensor protector. |
|
(c) Disengage the pin to remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.
|
Remove in this Direction |
|
|