Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001T5J1
Model Year Start: 2021 Model: Camry HV Prod Date Range: [10/2020 -           ]
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1697; Camera Position Adjustment Incomplete; 2021 - 2024 MY Camry HV [10/2020 -        ]

DTC

C1697

Camera Position Adjustment Incomplete

DESCRIPTION

This DTC is stored when the television camera controller judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1697

Camera Position Adjustment Incomplete

Camera initial setting has not been memorized
  • Camera view adjustment
  • Television camera controller

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

    Click here 2021 - 2024 MY Camry HV [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here 2021 - 2024 MY Camry HV [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

PROCEDURE

1.

ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT)

(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the television camera controller.

(1) Refer to camera view adjustment.

Click here 2021 - 2024 MY Camry HV [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

NEXT

2.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

OK:

DTC C1697 is not output.

HINT:

  • If DTC C1697 is output, perform the camera view adjustment again.
  • If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the television camera controller.
OK

END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE)
NG

REPLACE TELEVISION CAMERA CONTROLLER