| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001T5IS |
| Model Year Start: 2021 | Model: Camry HV | Prod Date Range: [10/2020 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1626; Steering Angle Sensor Failure; 2021 - 2024 MY Camry HV [10/2020 - ] | ||
|
DTC |
C1626 |
Steering Angle Sensor Failure |
DESCRIPTION
This DTC is stored if the television camera controller and rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.
Television Camera Controller
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C1626 |
Steering Angle Sensor Failure |
A fail flag is transmitted from the steering angle sensor |
|
Circumference Monitoring Camera Control Module |
Rear Television Camera Assembly
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
C1626 |
Steering Angle Sensor Failure |
A fail flag is transmitted from the steering angle sensor |
|
Parking Assist Camera |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
![2021 - 2024 MY Camry HV [10/2020 - ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
Click here
-
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click here
PROCEDURE
|
1. |
CHECK DTC OUTPUT |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
Chassis > Parking Assist Camera > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
DTC C1626 is output |
A |
|
DTC C1626 is not output |
B |
| B |
|
USE SIMULATION METHOD TO CHECK
|
|
|
2. |
REPLACE STEERING SENSOR |
(a) Replace the steering sensor with a new or known good one.
Click here
|
|
3. |
CHECK DTC OUTPUT |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
Chassis > Parking Assist Camera > Clear DTCs
(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
Chassis > Parking Assist Camera > Trouble Codes
|
Result |
Proceed to |
|---|---|
|
No DTCs are output |
A |
|
DTC C1626 is output ("Panoramic View Monitor") |
B |
|
DTC C1626 is output ("Parking Assist Camera") |
C |
| A |
|
END (STEERING SENSOR WAS DEFECTIVE) |
| B |
|
| C |
|
|
|