Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001T5IR
Model Year Start: 2021 Model: Camry HV Prod Date Range: [10/2020 -           ]
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1625; Open or Short in Steering Angle Sensor +B; 2021 - 2024 MY Camry HV [10/2020 -        ]

DTC

C1625

Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the television camera controller and rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.

Television Camera Controller

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

DTC Output from

C1625

Open or Short in Steering Angle Sensor +B

Open or short in steering angle sensor +B

  • Harness or connector
  • Steering sensor

Circumference Monitoring Camera Control Module

Rear Television Camera Assembly

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

DTC Output from

C1625

Open or Short in Steering Angle Sensor +B

Open or short in steering angle sensor +B

  • Harness or connector
  • Steering sensor

Parking Assist Camera

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • Since the panoramic view monitor system has functions that use the CAN communication system, first check that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
  • When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

    Click here 2021 - 2024 MY Camry HV [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here 2021 - 2024 MY Camry HV [10/2020 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: CALIBRATION

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE)

(a) Disconnect the K71 steering sensor connector.

Click here 2021 - 2024 MY Camry HV [10/2020 -        ]; BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: REMOVAL

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

K71-6 (ESS) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

K71-9 (IG) - K71-6 (ESS)

Ignition switch ON

11 to 14 V

K71-4 (BAT) - K71-6 (ESS)

Ignition switch off

11 to 14 V

OK

REPLACE STEERING SENSOR

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR