Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001T5HK |
Model Year Start: 2021 |
Model: Camry HV |
Prod Date Range: [10/2020 -
] |
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Blind spot monitor sensor
|
Blind spot monitor beam axis adjustment
|
-
Parking Suppor Brake System
-
Blind Spot Monitor System
|
|
Rear bumper assembly (w/ Intelligent clearance sonar system)
|
-
Measurement of ultrasonic sensor detection angle
-
Ultrasonic sensor detection angle registration
|
-
Parking Suppor Brake System
-
Intuitive Parking Assist System
|
|
PROCEDURE
1. REMOVE REAR BUMPER ASSEMBLY
Click here
2. REMOVE BLIND SPOT MONITOR SENSOR LH
(a) Disconnect the connector.
|
|
(b) Remove the 3 nuts and blind spot monitor sensor LH.
NOTICE:
Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.
3. REMOVE BLIND SPOT MONITOR SENSOR RH
(a) Disconnect the connector.
|
|
(b) Remove the 3 nuts and blind spot monitor sensor RH.
NOTICE:
Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.
|