| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001T5FV |
| Model Year Start: 2021 | Model: Camry HV | Prod Date Range: [10/2020 - ] |
| Title: AUDIO / VIDEO: ROOF ANTENNA: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during roof antenna assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedures |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision System |
|||
|
Lighting System (w/ AFS)(EXT) |
|||
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
|
Panoramic View Monitor System |
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
![2021 - 2022 MY Camry HV [10/2020 - 08/2022]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
Click here
2. REMOVE ROOF ANTENNA ASSEMBLY WITH COVER
|
(a) Disconnect the connector. |
|
|
(b) Remove the bolt. |
|
(c) Pull the washer and holder as shown in the illustration and remove the roof antenna assembly with cover.
|
Remove in this Direction |
3. REMOVE ROOF ANTENNA ASSEMBLY
(a) Pull the roof antenna assembly in the direction indicated by the arrow (1) shown in the illustration to disengage the 3 claws and 2 guides.
|
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
(b) Pull the roof antenna assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the roof antenna assembly.
(c) When reusing the roof antenna assembly:
|
(1) Remove the seal. |
|
|
|