- Steering angle neutral point (Initialize parking assist monitor system)
- Steering angle setting
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001T4VO |
| Model Year Start: 2021 | Model: Camry HV | Prod Date Range: [10/2020 - ] |
| Title: HEATING / AIR CONDITIONING: BLOWER UNIT: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane Tracing Assist System |
|
|
Pre-collision System |
|||
|
Lighting System (w/ AFS)(EXT) |
|||
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
|
Panoramic View Monitor System |
|
||
|
Steering sensor |
|
Parking assist monitor system |
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
![2021 - 2022 MY Camry HV [10/2020 - 08/2022]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
HINT:
Before removing the blower assembly, set the air conditioning to recirculation mode.
PROCEDURE
1. REMOVE AIR CONDITIONER UNIT ASSEMBLY
Click here
2. REMOVE NO. 2 AIR DUCT
Click here
3. REMOVE BLOWER ASSEMBLY
|
(a) Disconnect the connector. |
|
(b) Disengage each guide.
|
(c) Remove the 2 screws. |
|
(d) Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.
|
|