A25A-FXS (EMISSION CONTROL): FUEL TANK PRESSURE SENSOR: REMOVAL; 2021 - 2024 MY Camry HV [10/2020

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank pressure sensor (vapor pressure sensor) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Disconnect cable from negative (-) auxiliary battery terminal

Perform steering sensor zero point calibration

Lane Tracing Assist System

Pre-collision System

Lighting System (w/ AFS)(EXT)

Memorize steering angle neutral point

Parking Assist Monitor System

Panoramic View Monitor System

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

2020 - 2024 MY Camry HV [09/2019 - ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION

PROCEDURE

1. REMOVE REAR SEAT ASSEMBLY

Click here

2021 - 2024 MY Camry HV [10/2020 - ]; SEAT: REAR SEAT ASSEMBLY: REMOVAL

2. REMOVE REAR FLOOR SERVICE HOLE COVER

Click here

2021 - 2024 MY Camry HV [10/2020 - ]; A25A-FXS (FUEL): FUEL PUMP: REMOVAL+

3. REMOVE FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR)

(a) Remove the tube joint clip and pull off the fuel tank pressure sensor (vapor pressure sensor) from the fuel tank assembly.

NOTICE:

Remove any dirt or foreign matter on the fuel tank pressure sensor (vapor pressure sensor) before performing this work.
Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tank pressure sensor (vapor pressure sensor) has an O-ring that seals the fuel suction plate sub-assembly.
Perform this work by hand. Do not use any tools.
If the fuel suction plate sub-assembly and fuel tank pressure sensor (vapor pressure sensor) are stuck, carefully wiggle or push and pull the fuel tank pressure sensor (vapor pressure sensor) to release it. Pull the fuel tank pressure sensor (vapor pressure sensor) off the fuel suction plate sub-assembly carefully.

*1	Fuel Tank Pressure Sensor (Vapor Pressure Sensor)
*2	Fuel Suction Plate Sub-assembly
*3	Tube Joint Clip
*a	O-ring