A25A-FXS (FUEL): FUEL PRESSURE SENSOR: REMOVAL; 2021 - 2024 MY Camry HV [10/2020

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure sensor (fuel delivery pipe with sensor assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Auxiliary battery terminal is disconnected/reconnected

Perform steering sensor zero point calibration

Lane Tracing Assist System

Pre-collision System

Lighting System (w/ AFS)(EXT)

Memorize steering angle neutral point

Parking Assist Monitor System

Panoramic View Monitor System

Replacement of inverter with converter assembly

Resolver learning

DTCs are stored
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
Shock or vibration during acceleration

for Nickel Metal Hydride Battery

for Lithium-ion Battery

Replacement of ECM

Perform Vehicle Identification Number (VIN) registration

MIL illuminates

Replacement of fuel pressure sensor (fuel delivery pipe with sensor assembly)
Replacement of port fuel injector assembly
Replacement of throttle body with motor assembly
Cleaning the deposits from the throttle body with motor assembly
Replacement of EGR valve assembly
Gas leak from exhaust system is repaired

Inspection after repair

Poor idle, etc.
Engine start function, etc.

CAUTION:

Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

2020 - 2024 MY Camry HV [09/2019 - ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION

PROCEDURE

1. REMOVE FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY)

Click here

2021 - 2024 MY Camry HV [10/2020 - ]; A25A-FXS (FUEL): FUEL INJECTOR (for Port Injection): REMOVAL

NOTICE:

Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly.
If the fuel pressure sensor is removed, replace the fuel pressure sensor (fuel delivery pipe with sensor assembly) with a new one.