Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001SAVG |
Model Year Start: 2021 |
Model: Camry HV |
Prod Date Range: [10/2020 -
] |
Title: AUDIO / VIDEO: RADIO ANTENNA CORD: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedures
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Tracing Assist System
|
|
Pre-collision System
|
Lighting System (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking Assist Monitor System
|
|
Panoramic View Monitor System
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
2. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
Click here
3. REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Click here
4. REMOVE ANTENNA CORD SUB-ASSEMBLY
(a) w/o Navigation Antenna:
(1) Disengage the 5 clamps and remove the antenna cord sub-assembly.
(b) w/ Navigation Antenna:
(1) Disconnect the connector.
(2) Disengage the 2 claws.
(3) Disengage the 7 clamps and remove the antenna cord sub-assembly.
5. REMOVE ROOF HEADLINING ASSEMBLY
Click here
6. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
(a) Remove the adhesive tape from the roof headlining assembly.
for Normal Roof:
|
Adhesive Tape
|
-
|
-
|
for Moon Roof:
|
Adhesive Tape
|
-
|
-
|
for Panoramic Moon Roof:
|
Adhesive Tape
|
-
|
-
|
(b) Remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.
7. REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Manual (SOS) Switch)
(a) Disconnect the connector.
|
|
(b) Disengage the 5 clamps to remove the No. 5 antenna cord sub-assembly.
|