| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001SAUM |
| Model Year Start: 2021 | Model: Camry HV | Prod Date Range: [10/2020 - ] |
| Title: AUDIO / VIDEO: RADIO RECEIVER: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] | ||
REMOVAL
PROCEDURE
1. PRECAUTION (w/o Navigation System)
NOTICE:
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
NOTICE:
Click here
![2021 - 2024 MY Camry HV [10/2020 - ]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
2. PRECAUTION (w/ Navigation System)
NOTICE:
-
When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly or navigation ECU may not operate normally.
- After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.
NOTICE:
Click here
3. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Click here
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Click here
5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 7 Inch Display)
Click here
6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 9 Inch Display)
Click here
7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here
8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for 7 Inch Display)
|
(a) Disengage the clamp. |
|
(b) Remove the 4 bolts.
(c) Disengage the 2 clips and 2 claws as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |
(d) Disengage the 2 guides as shown in the illustration.
|
|
Remove in this Direction |
(e) Disconnect each connector and remove the radio and display receiver assembly with bracket.
9. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for 9 Inch Display)
|
(a) Disengage the clamp. |
|
(b) Remove the 4 bolts.
(c) Disengage the 5 clips as shown in the illustration.
|
|
Place Hand Here |
|
|
Remove in this Direction |
(d) Disengage the 2 guides as shown in the illustration.
|
|
Remove in this Direction |
(e) Disconnect each connector and remove the radio and display receiver assembly with bracket.
10. REMOVE CENTER INSTRUMENT CLUSTER FINISH UPPER PANEL ASSEMBLY (for 7 Inch Display)
(a) Disengage the 3 clips to remove the center instrument cluster finish upper panel assembly as shown in the illustration.
|
|
Remove in this Direction |
11. REMOVE NO. 2 RADIO RECEIVER BRACKET
|
(a) Remove the 2 screws and No. 2 radio receiver bracket. |
|
12. REMOVE NO. 1 RADIO RECEIVER BRACKET
|
(a) Remove the 2 screws and No. 1 radio receiver bracket. |
|
13. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
|
|