Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001SAOH |
Model Year Start: 2021 |
Model: Camry HV |
Prod Date Range: [10/2020 -
] |
Title: CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: REMOVAL; 2021 - 2024 MY Camry HV [10/2020 - ] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Millimeter wave radar sensor assembly
|
Adjust millimeter wave radar sensor assembly
|
-
Dynamic Radar Cruise Control System
-
Lane Tracing Assist System
-
Road Sign Assist System
-
Front Radar Sensor System
-
Pre-collision System
-
Lighting System (EXT)
|
Target Adjustment (Triangle Target):
or
Target Adjustment (Flat Surface Target):
or
Driving Adjustment:
|
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) Disconnect the connector.
|
|
(b) Remove the 2 bolts and screw.
|
Bolt
|
|
Screw
|
(c) Disengage the 2 guides and remove the millimeter wave radar sensor assembly.
NOTICE:
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.
|