| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001RX3Y |
| Model Year Start: 2021 | Model: Camry HV | Prod Date Range: [10/2020 - ] |
| Title: PRE-COLLISION: PRE-COLLISION SYSTEM: U041881; Invalid Data Received from Brake System Control Module Invalid Serial Data Received; 2021 - 2024 MY Camry HV [10/2020 - ] | ||
|
DTC |
U041881 |
Invalid Data Received from Brake System Control Module Invalid Serial Data Received |
DESCRIPTION
- The forward recognition camera receives signals from the skid control ECU (brake booster with master cylinder assembly) corresponding to the brake control status via the CAN communication line.
- When a brake control system malfunction signal is received from the skid control ECU (brake booster with master cylinder assembly), the forward recognition camera outputs U041881.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
U041881 |
Invalid Data Received from Brake System Control Module Invalid Serial Data Received |
Once 3 seconds elapse after turning the power switch on (IG), the forward recognition camera receives a brake control system malfunction signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. |
|
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
-
When the forward recognition camera is replaced with a new one or the windshield glass is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.
HINT:
Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.
One Time Recognition: Click here
![2021 - 2024 MY Camry HV [10/2020 - ]; CRUISE CONTROL: FRONT CAMERA: TARGET ADJUSTMENT(ONE TIME RECOGNITION)](/t3Portal/stylegraphics/info.gif)
Sequential Recognition: Click here
Driving Adjustment: Click here
PROCEDURE
|
1. |
CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM |
(a) Check the DTCs.
Chassis > ABS/VSC/TRAC > Trouble Codes
OK:
Electronically controlled brake system DTCs are not output.
HINT:
If U041881 is output in the pre-collision system, electronically controlled brake system DTCs may also have been output. Check the electronically controlled brake system first.
| OK |
|
| NG |
|
|
|