Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM100000001LCKD
Model Year Start: 2020 Model: Camry HV Prod Date Range: [09/2019 - 10/2020]
Title: CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B15CB11,B15CB13; Telephone Main Antenna Circuit Short to Ground; 2020 MY Camry HV [09/2019 - 10/2020]

DTC

B15CB11

Telephone Main Antenna Circuit Short to Ground

DTC

B15CB13

Telephone Main Antenna Circuit Open

DESCRIPTION

This DTC is stored when the DCM (telematics transceiver) detects an open or a short in the telephone antenna (main) circuit.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15CB11

Telephone Main Antenna Circuit Short to Ground

Telephone antenna (main) impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the power switch is on (IG) (Short circuit)

  • DCM (telematics transceiver)
  • Telephone and GPS antenna (for Roof Side)
  • Telephone and GPS antenna cord (No. 5 antenna cord sub-assembly)
  • Telephone and GPS antenna cord (No. 2 antenna cord sub-assembly)
  • Telephone and GPS antenna cord (antenna cord sub-assembly (for Type B))

B15CB13

Telephone Main Antenna Circuit Open

Telephone antenna (main) impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the power switch is on (IG) (Open circuit)

  • DCM (telematics transceiver)
  • Telephone and GPS antenna (for Roof Side)
  • Telephone and GPS antenna cord (No. 5 antenna cord sub-assembly)
  • Telephone and GPS antenna cord (No. 2 antenna cord sub-assembly)
  • Telephone and GPS antenna cord (antenna cord sub-assembly (for Type B))

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.

Click here 2020 MY Camry HV [09/2019 - 10/2020]; CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: PRECAUTION

PROCEDURE

1.

CHECK DTC

(a) Turn the power switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the power switch on (IG) and wait for 10 seconds or more.

(d) Turn the Techstream on.

(e) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

(f) Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

2.

INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 5 ANTENNA CORD SUB-ASSEMBLY)

(a) Disconnect the antenna connector from the Telephone and GPS antenna (for Roof Side).

*a

Component without harness connected (Telephone and GPS Antenna Cord (No. 5 Antenna Cord Sub-assembly))

(b) Disconnect the antenna connector from the telephone and GPS antenna cord (No. 2 antenna cord sub-assembly).

*a

Component without harness connected (Telephone and GPS Antenna Cord (No. 5 Antenna Cord Sub-assembly))

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

I-4 - H-3

Always

Below 1 Ω

I-4a - H-3a

Always

Below 1 Ω

I-4 or H-3 - Body ground

Always

10 kΩ or higher

NG

REPLACE TELEPHONE AND GPS ANTENNA CORD (NO. 5 ANTENNA CORD SUB-ASSEMBLY)

OK

3.

INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 ANTENNA CORD SUB-ASSEMBLY)

(a) Disconnect the antenna connector from the telephone and GPS antenna cord (No. 5 antenna cord sub-assembly).

*a

Component without harness connected (Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))

(b) Disconnect the antenna connector from the telephone and GPS antenna cord (antenna cord sub-assembly (for Type B)).

*a

Component without harness connected (Telephone and GPS Antenna Cord (No. 2 Antenna Cord Sub-assembly))

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G-3 - F-5

Always

Below 1 Ω

G-3a - F-5a

Always

Below 1 Ω

G-3 or F-5 - Body ground

Always

10 kΩ or higher

NG

REPLACE TELEPHONE AND GPS ANTENNA CORD (NO. 2 ANTENNA CORD SUB-ASSEMBLY)

OK

4.

INSPECT TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY (for Type B))

(a) Disconnect the antenna connector from the telephone and GPS antenna cord (No. 2 antenna cord sub-assembly).

*a

Component without harness connected

(Telephone and GPS Antenna Cord (Antenna Cord Sub-assembly (for Type B)))

(b) Disconnect the antenna connector from the DCM (telematics transceiver).

*a

Component without harness connected

(Telephone and GPS Antenna Cord (Antenna Cord Sub-assembly (for Type B)))

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

E-5 - C-1

Always

Below 1 Ω

E-5a - C-1a

Always

Below 1 Ω

E-5 or C-1 - Body ground

Always

10 kΩ or higher

NG

REPLACE TELEPHONE AND GPS ANTENNA CORD (ANTENNA CORD SUB-ASSEMBLY (for Type B))

OK

5.

CHECK TELEPHONE AND GPS ANTENNA (for Roof Side)

(a) Replace the telephone and GPS antenna (for Roof Side) with a known good one.

Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; CELLULAR COMMUNICATION: TELEPHONE AND GPS ANTENNA (for Roof Side): REMOVAL

(b) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

(c) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes

OK:

No DTCs are output.

OK

END (TELEPHONE AND GPS ANTENNA (FOR ROOF SIDE) IS DEFECTIVE)

NG

6.

REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (telematics transceiver) with a new one.

Click here 2020 MY Camry HV [09/2019 - 10/2020]; CELLULAR COMMUNICATION: DCM(TELEMATICS TRANSCEIVER): REMOVAL

NOTICE:

  • The power switch must be off.
  • Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION