Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM100000001F3JX |
Model Year Start: 2019 |
Model: Camry HV |
Prod Date Range: [09/2018 - 10/2020] |
Title: HEATING / AIR CONDITIONING: BLOWER UNIT: REMOVAL; 2019 - 2020 MY Camry HV [09/2018 - 10/2020] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
Steering sensor
|
-
Steering angle neutral point (Initialize parking assist monitor system)
-
Steering angle setting
|
Parking assist monitor system
|
for Initialization
for Calibration
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
HINT:
Before removing the blower assembly, set the air conditioning to recirculation mode.
PROCEDURE
1. REMOVE AIR CONDITIONER UNIT ASSEMBLY
Click here
2. REMOVE NO. 2 AIR DUCT
Click here
3. REMOVE BLOWER ASSEMBLY
(a) Disconnect the connector.
|
|
(b) Disengage each guide.
(d) Disengage the 2 claws and 2 guides and remove the blower assembly from the air conditioning radiator assembly.
|