Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM10000000163YZ |
Model Year Start: 2018 |
Model: Camry HV |
Prod Date Range: [07/2017 - 10/2020] |
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1626; Steering Angle Sensor Failure; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] |
DTC
|
C1626
|
Steering Angle Sensor Failure
|
DESCRIPTION
-
This DTC is stored if the television camera controller receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.
-
This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.
Television Camera Controller
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
DTC Output from
|
C1626
|
Steering Angle Sensor Failure
|
A fail flag is transmitted from the steering angle sensor
|
-
Steering sensor
-
Television camera controller
|
Panoramic View Monitor
|
Rear Television Camera Assembly
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
DTC Output from
|
C1626
|
Steering Angle Sensor Failure
|
A fail flag is transmitted from the steering angle sensor
|
-
Steering sensor
-
Rear television camera assembly
|
Parking Assist Camera
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
-
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click here
PROCEDURE
(a) Clear the DTCs.
Chassis > Panoramic View Monitor > Clear DTCs
Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Chassis > Panoramic View Monitor > Trouble Codes
Chassis > Parking Assist Camera > Trouble Codes
Result
|
Proceed to
|
DTC C1626 is output
|
A
|
DTC C1626 is not output
|
B
|
A
|
|
|
2.
|
REPLACE STEERING SENSOR
|
(a) Replace the steering sensor with a normally functioning one.
Click here
NEXT
|
|
|
(a) Clear the DTCs.
Chassis > Panoramic View Monitor > Clear DTCs
Chassis > Parking Assist Camera > Clear DTCs
(b) Check for DTCs.
Chassis > Panoramic View Monitor > Trouble Codes
Chassis > Parking Assist Camera > Trouble Codes
Result
|
Proceed to
|
No DTCs are output
|
A
|
DTC C1626 is output ("Panoramic View Monitor")
|
B
|
DTC C1626 is output ("Parking Assist Camera")
|
C
|
A |
|
END (STEERING SENSOR WAS DEFECTIVE)
|
|