INSTALLATION

PROCEDURE

1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

*a	Airbag Connector
*b	Airbag Connector Locking Button
	Push in this Direction

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

(d) Push in the airbag connector locking button to install the airbag connector.

(e) Engage the 3 claws to temporarily install the lower No. 2 instrument panel airbag assembly.

(f) Install the lower No. 2 instrument panel airbag assembly with the 3 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

NOTICE:

Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH

Click here

3. INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Click here

4. INSTALL NO. 1 METER HOOD CLUSTER

Click here

5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

6. INSTALL INSTRUMENT SIDE PANEL RH

Click here

7. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click here

9. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

Click here

10. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Click here

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

11. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Click here

12. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

13. INSPECT SRS WARNING LIGHT

Click here