| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM10000000162D0 |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - ] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): INSTALLATION; 2018 - 2024 MY Camry HV [07/2017 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Check that the power switch is off.
(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
(c) Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
|
*a |
Airbag Connector |
|
*b |
Airbag Connector Locking Button |
|
Push in this Direction |
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(d) Push in the airbag connector locking button to install the airbag connector.
|
(e) Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly. |
|
(f) Engage the 2 claws.
(g) Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Click here
![2018 - 2024 MY Camry HV [07/2017 - ]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
3. INSTALL NO. 1 METER HOOD CLUSTER
Click here
4. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here
5. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
6. INSTALL NO. 2 METER HOOD CLUSTER
Click here
7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
8. INSTALL INSTRUMENT SIDE PANEL LH
Click here
9. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
11. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
13. INSTALL LUGGAGE TRIM SERVICE HOLE COVER
Click here
14. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
15. INSPECT SRS WARNING LIGHT
Click here
|
|