P710 (HYBRID TRANSMISSION / TRANSAXLE): SHIFT LEVER: INSTALLATION; 2018 - 2024 MY Camry HV [07/2017

Last Modified: 11-20-2023	6.11:8.1.0	Doc ID: RM1000000015FSA
Model Year Start: 2018	Model: Camry HV	Prod Date Range: [07/2017 - ]
Title: P710 (HYBRID TRANSMISSION / TRANSAXLE): SHIFT LEVER: INSTALLATION; 2018 - 2024 MY Camry HV [07/2017 - ]

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Engage the clamp to connect the wire harness to the transmission floor shift assembly.

(b) Connect the shift lock control ECU connector.

(d) Connect the transmission control switch connector.

(e) w/ Rear Air Duct:

(1) Install the clip to the No. 1 console box duct.

(f) Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.

(g) Tighten the 4 bolts in the order shown in the illustration.

Torque:

12 N·m {122 kgf·cm, 9 ft·lbf}

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

Before connecting the transmission control cable assembly, check that the shift lever is in N.

(a) Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration and pull the lock piece outward.

*a	Slider
*b	Lock Piece
*c	Slide
*d	Pull

(b) Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.

*a	Lock Nut
*b	Push in
*c	Stopper

NOTICE:

After installation, check that the outer part of the stopper is as shown in the illustration.

Stopper

(d) Connect the transmission control cable assembly to the transmission floor shift assembly.

NOTICE:

Check that the lock piece is pulled out.
Push the end of the transmission control cable assembly all the way to the base of the transmission floor shift assembly pin.
Connect the transmission control cable assembly so that the lock piece faces the driver side.

*a	Lock Piece
*b	Adjuster Case

(e) Push the lock piece into the adjuster case.

*a	Lock Piece
*b	Push in
*c	Adjuster Case

NOTICE:

Check that the shift lever is in N.
Securely push in the lock piece until the slider lock is engaged.

When pushing in the lock piece of the adjuster case to lock it, remove your hand from the lever shaft.

*1	Transmission Control Cable Assembly
*a	Lever Shaft

When pushing in the lock piece of the adjuster case to lock it, do not move the lever shaft or transmission control cable assembly forward or backward.

(f) After adjusting the shift lever position, check the position and operation of the shift lever. If there is a problem, adjust the shift lever position again.

3. INSTALL CONSOLE BOX ASSEMBLY

Click here

4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Click here

5. INSTALL SHIFT LOCK RELEASE BUTTON COVER

(a) Engage the 2 claws and guide to install the shift lock release button cover to the rear upper console panel sub-assembly.

6. INSPECT SHIFT LEVER POSITION

Click here

7. ADJUST SHIFT LEVER POSITION

Click here