Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM1000000015EHZ |
Model Year Start: 2018 |
Model: Camry HV |
Prod Date Range: [07/2017 - 09/2018] |
Title: MAINTENANCE: AUXILIARY BATTERY: REMOVAL; 2018 MY Camry HV [07/2017 - 09/2018] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Auxiliary battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
PROCEDURE
1. PRECAUTION
NOTICE:
-
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click here
-
When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER
(a) Disengage the 2 claws and remove the luggage trim service hole cover.
|
|
3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
|
|
4. REMOVE AUXILIARY BATTERY
(a) Disengage the 2 claws and open the battery terminal connector cover in the order shown in the illustration.
|
|
(b) Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.
|
|
(c) Disconnect the battery hose from the auxiliary battery.
|
|
(d) Remove the bolt and remove the No. 3 battery clamp as shown in the illustration.
|
Remove in this Direction
|
(e) Remove the auxiliary battery.
|