- Dynamic radar cruise control system
- Pre-collision system
- Forward recognition camera system
- Lane departure alert system (w/ Steering Control System)
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM10000000158R3 |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - 10/2020] |
| Title: CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Millimeter wave radar sensor assembly |
Adjust millimeter wave radar sensor assembly |
|
|
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
![2018 - 2020 MY Camry HV [07/2017 - 10/2020]; EXTERIOR PANELS / TRIM: FRONT BUMPER: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
|
(a) Disconnect the connector. |
|
(b) Remove the 2 bolts and screw.
|
Bolt |
|
Screw |
(c) Disengage the 2 guides to remove the millimeter wave radar sensor assembly.
NOTICE:
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.
|
|