| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM10000000157C4 |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - ] |
| Title: LIGHTING (EXT): LIGHTING SYSTEM (w/ AFS): Turn Signal Switch Circuit; 2018 - 2024 MY Camry HV [07/2017 - ] | ||
|
Turn Signal Switch Circuit |
DESCRIPTION
The steering sensor receives the turn signal switch information and controls the turn signal lights.
WIRING DIAGRAM
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Steering Angle Sensor / Data List.
(e) Read the Data List according to the display on the Techstream.
Chassis > Steering Angle Sensor > Data List
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Turn Signal Switch (Right) |
Turn signal switch (right turn position) signal |
OFF or ON |
OFF: Turn signal switch not in right turn position ON: Turn signal switch in right turn position |
- |
|
Turn Signal Switch (Left) |
Turn signal switch (left turn position) signal |
OFF or ON |
OFF: Turn signal switch not in left turn position ON: Turn signal switch in left turn position |
- |
|
Cornering Light/Front Side Illuminate Light Switch |
Turn signal switch (full turn) signal |
OFF or ON |
OFF: Turn signal switch not in left or right turn position ON: Turn signal switch in left or right full turn position |
- |
Chassis > Steering Angle Sensor > Data List
|
Tester Display |
|---|
|
Turn Signal Switch (Right) |
|
Turn Signal Switch (Left) |
|
Cornering Light/Front Side Illuminate Light Switch |
OK:
Normal conditions listed above are displayed.
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
|
|
2. |
INSPECT TURN SIGNAL SWITCH |
(a) Remove the turn signal switch.
Click here
![2018 - 2024 MY Camry HV [07/2017 - ]; LIGHTING (EXT): HEADLIGHT DIMMER SWITCH: REMOVAL](/t3Portal/stylegraphics/info.gif)
(b) Inspect the turn signal switch.
Click here
| NG |
|
|
|
3. |
INSPECT STEERING WHEEL SWITCH HOUSING |
(a) Remove the steering wheel switch housing.
Click here
(b) Inspect the steering wheel switch housing.
Click here
| OK |
|
REPLACE STEERING SENSOR
|
| NG |
|
REPLACE STEERING WHEEL SWITCH HOUSING
|
|
|