Last Modified: 11-20-2023 6.11:8.1.0 Doc ID: RM1000000015668
Model Year Start: 2018 Model: Camry HV Prod Date Range: [07/2017 - 10/2020]
Title: AUDIO / VIDEO: STEREO COMPONENT AMPLIFIER: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during stereo component amplifier assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedures

Effect/Inoperative Function when Necessary Procedure not Performed

Link
*: When performing learning using the Techstream.

Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; PARK ASSIST / MONITORING: INTELLIGENT CLEARANCE SONAR SYSTEM: CALIBRATION

Disconnect cable from negative auxiliary battery terminal

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

2018 - 2020 MY Camry HV [07/2017 - 10/2020]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Pre-collision system

Intelligent clearance sonar system*

Lighting system (w/ AFS)(EXT)

Memorize steering angle neutral point

Parking assist monitor system

2018 - 2024 MY Camry HV [07/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION

Panoramic view monitor system

2018 - 2020 MY Camry HV [07/2017 - 10/2020]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY LH

Click here 2018 - 2020 MY Camry HV [07/2017 - 10/2020]; SEAT: FRONT SEAT ASSEMBLY (for Power Seat): REMOVAL

2. REMOVE AUDIO AMPLIFIER COVER

(a) Remove the 3 clips and audio amplifier cover.

3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET

(a) Disconnect each connector.

(b) Disengage the clamp.

(c) Turn back the front floor carpet assembly and front floor mat as shown in the illustration.

(d) Remove the bolt.

(e) Disengage the 2 guides and remove the stereo component amplifier assembly with bracket as shown in the illustration.

Remove in this Direction (1)

Remove in this Direction (2)

4. REMOVE NO. 1 AMPLIFIER BRACKET

(a) Remove the 2 screws and No. 1 amplifier bracket.

5. REMOVE NO. 2 AMPLIFIER BRACKET

(a) Remove the 2 screws and No. 2 amplifier bracket.

6. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY