INSTALLATION

PROCEDURE

1. INSTALL REAR STABILIZER BUSHING

(a) Install the 2 rear stabilizer bushings to the rear stabilizer bar.

NOTICE:

Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.

2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET LH

(a) Install the rear No. 1 stabilizer bar bracket LH to the rear stabilizer bushing.

NOTICE:

Be sure to install the rear No. 1 stabilizer bar bracket LH so that each arrow mark faces the front of the vehicle.

*a	Arrow Mark
	Front of the Vehicle

3. INSTALL REAR NO. 1 STABILIZER BAR BRACKET RH

HINT:

Perform the same procedure as for the LH side.

4. INSTALL REAR STABILIZER BAR

(a) Install the rear stabilizer bar, rear No. 1 stabilizer bar bracket LH, rear No. 1 stabilizer bar bracket RH and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 bolts. Torque: 78 N·m {795 kgf·cm, 58 ft·lbf} NOTICE: Ensure that the identification mark faces the right side of the vehicle. Temporarily tighten the bolt (A) and then fully tighten the 2 bolts in the order of (B) and (A).

*a Identification Mark

5. STABILIZE SUSPENSION

Click here

6. INSTALL REAR STABILIZER LINK ASSEMBLY LH

(a) Install the rear stabilizer link assembly LH with the nut (A). Torque: 75 N·m {765 kgf·cm, 55 ft·lbf} HINT: If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

(b) Install the rear stabilizer link assembly LH with the bolt and nut (B).

Torque:

75 N·m {765 kgf·cm, 55 ft·lbf}

7. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.

8. INSTALL CENTER EXHAUST PIPE ASSEMBLY

Click here

9. INSTALL REAR WHEEL

Click here

10. INSPECT FOR EXHAUST GAS LEAK

Click here