| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM100000001526O |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - ] |
| Title: POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: C1552,C1554; PIG Power Supply Voltage; 2018 - 2024 MY Camry HV [07/2017 - ] | ||
|
DTC |
C1552 |
PIG Power Supply Voltage |
|
DTC |
C1554 |
Power Supply Relay Failure |
DESCRIPTION
When a problem occurs in the PIG power source and power supply relay system, the fail-safe function works to stop the power assist.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Warning Indicate |
Return-to-normal Condition |
Note |
|---|---|---|---|---|---|---|
|
C1552 |
PIG Power Supply Voltage |
PIG power source circuit malfunction |
|
EPS warning light: Comes on |
Power switch is turned on (IG) again |
- |
|
C1554 |
Power Supply Relay Failure |
Power source relay circuit malfunction |
|
EPS warning light: Comes on |
Power switch is turned on (IG) again |
- |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click here
![2018 - 2024 MY Camry HV [07/2017 - ]; POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: CALIBRATION](/t3Portal/stylegraphics/info.gif)
- Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (RACK AND PINION POWER STEERING GEAR ASSEMBLY - BODY GROUND) |
(a) Disconnect the C71 rack and pinion power steering gear assembly connector.
|
*a |
Front view of wire harness connector (to Rack and Pinion Power Steering Gear Assembly) |
- |
- |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
C71-8 (PIG) - Body ground |
Power switch on (IG) |
9 to 16 V |
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
C71-7 (PGND) - Body ground |
Always |
Below 1 Ω |
| OK |
|
REPLACE RACK AND PINION POWER STEERING GEAR ASSEMBLY
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|