Last Modified: 11-20-2023 |
6.11:8.1.0 |
Doc ID: RM10000000150ZM |
Model Year Start: 2018 |
Model: Camry HV |
Prod Date Range: [07/2017 - 10/2020] |
Title: A25A-FXS (ENGINE CONTROL): CAMSHAFT TIMING CONTROL MOTOR: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cam timing control motor with EDU assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Auxiliary battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
|
Pre-collision system
|
Intelligent clearance sonar system*
|
Lighting system (w/ AFS)(EXT)
|
Memorize steering angle neutral point
|
Parking assist monitor system
|
|
Panoramic view monitor system
|
|
-
Replacement of cam timing control motor with EDU assembly
-
Removal and installation of a cam timing control motor with EDU assembly
|
Inspection after repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
PROCEDURE
1. REMOVE LUGGAGE TRIM SERVICE HOLE COVER
Click here
2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click here
3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Click here
4. REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
(a) Disconnect the cam timing control motor with EDU assembly connector.
|
|
(b) Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing gear cover assembly.
NOTICE:
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
5. REMOVE CAM TIMING CONTROL MOTOR O-RING
(a) Remove the cam timing control motor O-ring from the No. 2 timing gear cover assembly.
|
|
|