- Synchronize the vehicle information
- Perform headlight ECU sub-assembly LH initialization
| Last Modified: 11-20-2023 | 6.11:8.1.0 | Doc ID: RM1000000014YO5 |
| Model Year Start: 2018 | Model: Camry HV | Prod Date Range: [07/2017 - 10/2020] |
| Title: LIGHTING (EXT): HEADLIGHT ECU: REMOVAL; 2018 - 2020 MY Camry HV [07/2017 - 10/2020] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Front bumper assembly (w/ Panoramic view monitor system) |
Front television camera view adjustment |
Panoramic view monitor system |
|
|
Headlight ECU sub-assembly LH |
|
Lighting system (w/ AFS)(EXT) |
|
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE HEADLIGHT ASSEMBLY
Click here
![2018 - 2020 MY Camry HV [07/2017 - 10/2020]; LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY
NOTICE:
- Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
- If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
|
(a) Remove the 3 screws. |
|
|
(b) Separate the connector cover from the headlight ECU sub-assembly. |
|
|
(c) Disconnect the 2 connectors to remove the headlight ECU sub-assembly. |
|
3. REMOVE HEADLIGHT GASKET
NOTICE:
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
|
(a) Remove the headlight gasket. |
|
|
|